SCUBA REGULATOR TESTER — v0.14

Body + matching lid + two button clips.
Native project: Bambu X1 Carbon, 0.4mm nozzle, black Generic PLA,
Smooth PEI / High Temp Plate, 0.20mm layers. 100% infill, five walls, six top/bottom layers. Estimated 3h59m / 81.76g.
Use the supplied body print orientation and keep its two support blockers.
Exterior supports remain. Do not automatically generate supports inside the airway.

The optional EEMB LP852040/852040 battery fits under the display.
Insert battery before sensor and board. See DESIGN-AND-VALIDATION.md.
Use M2.5x10 countersunk screws directly into plastic; no heat-set inserts.
For an existing glued v0.11 housing use its separate retrofit lid instead.

Software validation: closed body airway with lid removed; intentional leak
control detected; zero supports inside airway; maximum Bridge path6.751mm,
maximum actual-bead unsupported roof run5.399mm; battery and sensor clearances.
These files have not established physical printed fit, leakage or flow acceptance.
Inspect the print and check the body seal, sensor seals, draw resistance and
pressure response before using measurements. Follow the regulator maker's
servicing procedure. This is not a work-of-breathing or certification machine.

Instructions, wiring, firmware and device licence:
https://www.regulatortester.com/build
All measurement functions: EUR25 once per device; hardware and printing separate.

Default print project: SCUBA-Regulator-Tester-v0.14-X1C-PLA-100pct.3mf
100% zig-zag (rectilinear) infill. Geometry is unchanged from v0.14.
Current profile/toolpath evidence: validation/100pct/.
Original CAD/reference evidence: validation/reference-v0.14/.
100% infill does not establish physical gas tightness; leak-test the print.
